Pinwheel cards are a new trend that crafters everywhere are trying out! They are very impressive, and actually quite simple to make. I even found a version that fits in the usual medium envelope from Stampin’ Up!
You will need the following cuts of cardstock, all the same colour:
5.75 x 4.25”
Scored at .75, 1.5, 2.25, 3” along short side
3 pieces 2.75 x 4.25”
Burnish all the score lines on your large piece of cardstock. Apply a strip of Tear & Tape to the very last panel, as shown below.
Fold the cardstock so that the four small panels create a box as shown below. Remove the backing on the Tear & Tape to attach. This is the centre of your pinwheel – and already has one ‘arm’ attached!
Apply another strip of Tear & Tape as shown below.
Peel off the backing of the Tear & Tape and attach another piece of cardstock going in the opposite direction of the first ‘arm’. Now your pinwheel has two arms!
Repeat the previous steps to add the third and fourth ‘arms’ to the pinwheel.
Now it’s time to add your Designer Series Paper!
four pieces 1.75 x 4”
four pieces 2.5 x 4”
Start laying out your DSP pieces to decide where they will all go. Each of the arms will have a piece of DSP on each side.
Choose one segment of the card to be the ‘front’ (i.e., what the recipient will see first when the open the envelope). Attach the DSP to this part of the card first; then, wrap some ribbon around from the back, at the left.
The picture below shows the back of the panel with the ribbon on it. Attach your DSP overtop of the ribbon.
Finish attaching all the rest of the DSP. You might want to add a piece of white cardstock to write your message.
Then, finish decorating the front of the card.
If you make a pinwheel card yourself, be sure to share a photo with me! I love to see your creations!
Happy Stampin’!Product List
Thanks for reading today! If you enjoyed this post or found it useful, please consider sharing it! And be sure to join me on Facebook for daily content!