Tutorial: Bay Window Card

Remember back in October when I asked you to vote on which tutorial I should include in my newsletter – the Double Fan Fold card or the Bay Window card?

Well, once I counted all the votes, the Double Fan Fold card won, and I shared that tutorial in the November newsletter (and later, here on the blog). But some of you were clever enough to guess that I might share the Bay Window card tutorial the following month, and you were correct – so here it is!

Here is the cardstock and paper you will need:
Card Base:  4.25 x 11”
White insert: 4 x 5.25″
Mat (contrasting colour): 4 x 6″ (see note below)
DSP: 3-7/8 x 5-7/8″

Note: Because I chose cardstock and DSP that matched so closely, I chose to put a layer of white in between to add contrast. If you are using DSP and cardstock that have a good amount of contrast, you could skip the middle layer and cut your DSP to 4 x 6″.

Score your cardbase along the long side at 3/8”, 1-7/8”, 3-5/8”, 5-1/8” and 5-1/2”. Burnish your folds and start to create the bay window shape.

With your DSP (or mat layer, if using), trim along the short side at 1-3/8”, 1-5/8” and 1-3/8”. You will be left with four pieces; if your DSP has a continuing pattern, keep your pieces in order as you cut, so you can attach them to the cardbase in order.

(If you’re using a mat layer, your DSP cuts will be 1.25″, 1.5″, and 1.25″. Go ahead and attach your DSP to your mat layers.)

Attach your white insert to the inside of your card.

Your fourth panel of DSP will attach on top of the white insert.

Put a strip of Tear and Tape adhesive in the smallest section between the score lines – just to the left of the white insert.

Peel the backing off the Tear and Tape, and close the card to adhere.

The step below is optional, and depends on what colour cardstock/DSP you are using. If you like, you can “trim” your window by attaching two small pieces of contrasting cardstock that measure 4-1/8 x 1/4″. Attach these to the small sections at either side of your bay window.

Now attach your three DSP panels, in order so that the pattern is continuous across the card.

Stamp your desired sentiment and punch out. Use dimensionals to attach. I found it helpful to attach the dimensionals on the right side and middle of the punched shape; that way, the front card flap could slide underneath the left side of the punched shape before stopping at the dimensionals in the centre.

Finally, decorate your card as desired!

Have you made any Bay Window cards? Share them in the comments below! I love to see your creations!

Happy Stampin’!

Product List

Please visit my 24/7 online store by clicking above, or contact me: lauralyzer@gmail.com.

Have you subscribed to my monthly newsletter? You’ll receive project tutorials and inspiration, as well as all workshop dates and special promotion news. Don’t miss out, sign up today!

%d bloggers like this: